Dear all Expert,does 6509 sup 720 12.2 support priority or bandwidth

[doraemon1688]

dear all

when i implement

Policy Map qos-in

Class c-video

priority 1 (%)

or

bandwidth

in sup 720 5/2 module

it show

bandwidth percent command is not supported in input direction for this interface

or

priority command is not supported in input direction for this interface

the question is does 6509 support priority or bandwidth command with policy-map

or

it can support in other interface like

48 port 10/100/1000 fiber or utp module

pls advice

tks

[u0087672js]

I am using Sup 720's and it is supported on mine.

policy-map NJ_voice

class NJ_voice

priority percent 25

[doraemon1688]

hi

tks

and can you tell me your IOS version

and which interface you apply service-policy

Wan Module? or ethernet Module

Module Model?

tks

[doraemon1688]

I STUDY 6500 PFC CONFIG GUIDE

IT WROTE PFC DOES NOT SUPPORT

IS THAT RIGHT?

Policy Map Command Restrictions

PFC QoS does not support these policy map commands:

• class class_name destination-address

• class class_name input-interface

• class class_name protocol

• class class_name qos-group

• class class_name source-address

Policy Map Class Command Restrictions

PFC QoS does not support these policy map class commands:

• bandwidth

• priority

• queue-limit

• random-detect

• set qos-group

• service-policy

[u0087672js]

IOS version 12.2(33)SXH2a.

Its applied to a Multilink interface. I dont believe you can apply it to a ethernet switchport. Usually you would have your switch ports trust any QoS markings so they are passed through the network and then have your service policy which is on your WAN interface, catching those marked packets and dealing with them accordingly.

[Prashanth Krishnappa]

LLQ is not supported on ethernet/VLAN interfaces in 6500s