Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Dear All

Dear All,

We have 4503E switch  when I restart  the switch it will going to be a roman mode we changed

config-register 0x102  value.But again same problem.anyone please sagest the what is the problem

I am attaching show tech details.

Thanks,

Narsimaha

Everyone's tags (1)
1 REPLY
Cisco Employee

Dear All

Hi Narsimaha,

There are several reasons on why the device goes into rommon mode.

configuration register issue

valid image is not present in the device

corrupted image

image compatibility with the device( DRAM requirements)

++ Have you synced the config after changing config-register value?

rommon>confreg 0x2102

rommon>sync

++ Check whether the boot variable is correct or not

rommon>set

The output of the above command will show the bootvariable configured.

To clear the boot variable,

rommon>BOOT=

To set the boot variable

rommon> BOOT=booflash:image name

rommon>sync

Also pls check whether valid image is present in the memory devices

rommon>dev

The above o/p will display the list of memory devices present and dir : will show the contents of the memory device.

Hope this helps

Cheers

Somu

P.S: Rate helpful posts

258
Views
0
Helpful
1
Replies