Hi, i have been trying to use debug Packet command on cli ( with terminal monitor on). But i am not able to see any result ? why is that so. I can see various other debug results but i couldnt see a single line shown after debug packet. Is this command not working anymore or is there any other issue ??
Just wanted to say thanks much. Adding the access list (with the log option) on the appropriate interface, did it for me. It produced the results I wanted. Before I was not able to see the expected output from packets to the far end device, after the acl I could see activity to the destinations of interest.
Where would we be without this forum and others like it?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.