Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Debuging CAT 6500

Hi,

We had a requirement to trace some packet going in and out of the CAT 6500 and 7206 VXR router

based on the source and destination or based on the protocol SIP and h323

is it recomded to use the commands like debug ip tcp packet address XXX

since our traffic on the CAT and Routers are about 300 meg

kindly suggest us how we can trace the packet

2 REPLIES

Re: Debuging CAT 6500

Cisco Employee

Re: Debuging CAT 6500

You have multiple ways to do that on 6500.

- access-list with log as highlighted above

- Mini protocol analyser if you run 12.2(33)SXI . see :http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SX/configuration/guide/mpa.html

- Use Span , RSPAN : http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SX/configuration/guide/span.html

- Use VACL capture : http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SX/configuration/guide/vacl.html

HOpe this helps,

Roland

126
Views
5
Helpful
2
Replies
CreatePlease to create content