cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
892
Views
0
Helpful
0
Replies

Dedicated Bandwidth for VLAN

tom.neteng
Level 1
Level 1

Could someone give me a brief tutorial on how to effect a bandwidth policy that gives a dedicated amount of bandwidth to a particular VLAN on a 3560E?

 

I am attempting to give a particular client dedicated bandwidth on a new VLAN, which the client will be the only device on.  This is for a special event, and will only be used in this particular circumstance.

 

I found the following in another post--could someone tell me if this would work for my purposes:

 

class-map match-all PRIORITY

match ip address 101

!

policy-map BANDWIDTH

class PRIORITY

bandwidth (What is this unit of measurement? Need 25 Mbps)

!

interface (This would go on the link to the router from the core, correct?)

service-policy output BANDWIDTH

!

access-list 101 permit ip x.x.x.x any (Can you do this to an entire VLAN rather than a single IP?)

 

Tom

 

 

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco