Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

default frame distribution mode

Hi,

I would like to know what's the default frame distribution mode for switch 2926G. I know that this device model is End_of_Support but actually I need to know if the related command ("set port channel all distribution mac both") is default or not.

Thank you.

Marcelo

1 REPLY
Silver

Re: default frame distribution mode

Frame distribution method

Set port channel all distribution mac both is non Default configuration.

show config

This command shows non-default configurations only.

Use 'show config all' to show both default and non-default configurations.

For further information click this link.

http://www.cisco.com/en/US/products/hw/switches/ps679/products_tech_note09186a008009495b.shtml

105
Views
0
Helpful
1
Replies
CreatePlease to create content