Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Default Gateway not set on Cisco 2601

                   I am running 12.2 on an old Cisco 3640. It is not connected to the network and I am looking at it using the console. I have copied the config from another 3640 that is in production. The config is the exact same but when I do a sh ip rpoute on the not connected router I get a Gateway of last resort not set. The config is the same on both routers. Am I getting this because the router is not connected to my network?

Any help

2 ACCEPTED SOLUTIONS

Accepted Solutions
Purple

Default Gateway not set on Cisco 2601

Hi,

if the router can't recurse the next-hop to an outgoing interface then the static default route will not get installed.

Regards

alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
VIP Super Bronze

Default Gateway not set on Cisco 2601

Hi,

If the router is not connected to the network, that means all interfaces are in down state, therefor the ips will not show in the routing table.

HTH

3 REPLIES
Purple

Default Gateway not set on Cisco 2601

Hi,

if the router can't recurse the next-hop to an outgoing interface then the static default route will not get installed.

Regards

alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
VIP Super Bronze

Default Gateway not set on Cisco 2601

Hi,

If the router is not connected to the network, that means all interfaces are in down state, therefor the ips will not show in the routing table.

HTH

New Member

Default Gateway not set on Cisco 2601

Thanks guys, Appreciate it

313
Views
0
Helpful
3
Replies