1.) You created a route map named "ospf" but haven't applied it anywhere for redistribution. It matches an ACL, and then nothing.
2.) You haven't set the seed metric on the eigrp instance. When you redistribute another protocol into eigrp, you must give it a default eigrp metric. Remember, after redistribution, this OSPF route is going to be masquerading around in your eigrp domain as an eigrp route. All eigrp routes have their metrics associated with them, so give these OSPF routes theirs.
PS. Do you need those crytpo certificates enabled? If not, you can get rid of them by doing a no crypto pki trustpoint TP-self-signed-998521732. It will ask you if you're sure, and you will confirm.
Then configure "no ip http secure-server"
Save the config, then reload (when you have permission to do so, of course).
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...