Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Defining traffic flow

Hello,

I have a 7206 with 2x FE100 interfaces. I am looking for a way to define within the router IOS how to define which interface defined subnets pass traffic over.

For example I have FE1/0 connect to a LAN, I have 192.168.1.0/24 connected to this segment. On FE2/0 I have another LAN, 192.168.2/0/24 connected to this segment. I need to be able route all traffic LAN and WAN traffic for segment one, only on FE1/0 and vise versa on segment 2. Can I do this with an ACL applied seperatly to each interface? Also, how can I define a default route (0.0.0.0 0.0.0.0 192.168.1.x) or (0.0.0.0 0.0.0.0 192.168.2.x). I have two sperate networks, all internet users, who will need to get out. Each of these interface are going to routed to different network routers.

Jhottle

1 REPLY

Re: Defining traffic flow

Hi,

I guess that you need to do source based routing PBR (Policy Based Routing).

please review these documents and get back if you have further problems:

Policy-Based Routing

http://www.cisco.com/warp/public/732/Tech/plicy_wp.htm

Configuring Policy-Based Routing

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fqos_c/fqcprt1/qcfpbr.htm

HTH, please do rate all helpful replies,

Mohammed Mahmoud.

144
Views
0
Helpful
1
Replies
CreatePlease to create content