My company bought a Catalyst 2960(flash:c2960-lanbase-mz.122-35.SE5) but the logs at show log command are displaing a very delayed time from the current clock time (show clock) in the switch. Is it a IOS release issue or there is a specific command to syncronize the logs with the clock sets ?
Normally the timestamps on the messages are pretty accurate, and are exactly what the clock says at the time the event occurred.
I wonder whether you have your timezone set up correctly, and whether your logging is configured to show you local time.
For your timezone, you should use the configuration command clock timezone XYZ -3. I'm presuming that Brazil has UTC-3 normally in Winter, and that your winter timezone is called XYZ.
Then tell it about your summertime timezone. That will require a command like clock summer-time ZYX recurring last Sun Oct 03:00 last Sun Apr 02:00. That tells it the dates to apply an hour offset for daylight saving time, and the name of your summertime timezone.
Once you have set up your timezones, set the clock to your local time, or let NTP do it for you.
Now the bit you asked about. You need service timestamps log datetime localtime. I reckon it is that localtime parameter you are missing.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...