Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Dell Blade-switch - 3130 logging source

Hi,

We have Dell blade switch of 3130 series. We have configured loopback 0 interface as identifrer for OSPF process. Also we have fastethernet 0 as a management interface which is used as source for tacacs authentication, domain-lookup, ntp  etc. But when we give following command it is not accepting

logging source-interface fastethernet0

It takes the command without any error but it is not see in running configuration.

Is there a chance that if we have loopback 0 with IP address any other interface can not be used by switch as source-interface for logging.

Has it anything to do with vrf configuration which we are using?

Please share the experience.

Thanks

Subodh

141
Views
0
Helpful
0
Replies