I'm trying to set up the following solution but having trouble working it out, so hopefully someone can help
I have a DSL line wth a BT DSL router/modem- this is working fine, if i attach a pc to one of the ports it picks up an IP (192.168.1.x/24) and have an internet connection. DSL router/modem has an internal address of 192.168.1.0/24 the gateway being 192.168.1.1
I have attached a patch from this DSL router/modem to SWITCH1 port 3
port 2 of SWITCH1 is a attached to a PC
port 1 of SWITCH1 is atached to F0/1 of Router1 (Trunk)
With the dunp of configs attached I can ping from the PC the 192.168.1.1 & 172.18.0.254 but cannot get a internet connection.
Just so you know I'm trying this setup because I want to eventually setup a LAN-LAN VPN tunnel from the Cisco 1700 router.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...