Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Designging core switch

Hi,

Can any one help on this, if the network consists of 2 core switches and 10+ distribution switch, is it feasible to configure the VLANs in distribution switch. Whcih is the best config to do when designing a VLAN.

Is it good to keep the VLANs under core switch or distribution switch.

3 REPLIES

Re: Designging core switch

Not knowing ur full requirement, I will give a generic response.

I usually try to seperate VLANs from access to cross to core. so, I use access vlans on access switches , then route back to core switch on over one uplink VLAN.

HTH

Sam

New Member

Re: Designging core switch

That means no vlans are entering into core switch. In that case where can we run the HSRP.

Re: Designging core switch

Are u planning in terminating ur vlans on access switches. what I have in mind is :

ACC_SW01==CUST==ACCSW02, all on same VLAN, then you can run HSRP on access switches.

Please add more info on your requirement, so we can help you better.

HTH

Sam

115
Views
3
Helpful
3
Replies