Destination NAT from outside segment

[achrich]

We have a router which connects 2 sites however for various reason the inside/outside are back to front in logical terms.

There is now a requirement to perform a static destination NAT however this needs to happen on the outside NAT segment.

Is this possible without reconfiguring all the NAT or should I consider a PBR ( not a CPU intensive router )

Any pointers would be helpful.

[Jon Marshall]

Andrew

It may be easier to help you if you could

1) draw a quick layout of the router connections

2) give some ip addresses as examples of what you need.

Jon

[achrich]

hi - thanks for the reply. Managed to figure it out in the end.