Due to ip address confliction issues I am trying to change the destination address of traffic hitting my router when sourced from a 3rd party router.
So, if traffic sourced from 10.0.0.0/24 from 3rd party router targets a loopback on my router, lets say Lo1 - 192.168.1.1/32 can I then modify the destination to 172.16.1.1 and then forward the traffic further into my network where the server on 172.16.1.1 lives. If it's possible to nat the source to 192.168.1.1 also that would be great. I am using 1800 routers and statics for the routing. Is this possible?
This is very roughly the setup (missing the /30 networks between the routers)
10.0.0.0/24 <-->Lo1 (192.168.1.1/32) <--> Server 172.16.1.1
if you are trying to access to server (private address ) from the network 10.0.0.0, the best way is to use Nat Overloading method (PAT) , for example , you can specify all packets comes with port=5001 must be forwarded to server 172.16.1.1
NAT overload would change the source of the packets. I'm trying to get the users (10.0.0.0/24) to target 192.168.1.1 and this be changed to 172.16.1.1 by nat or any other means. This is because the users already have 172.16.1.1 on their network, hence the ip address conflict.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...