Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Destination NAT

All,

I need to be able to NAT to specific addresses on a destination basis. As you can see from my config below I have created a pool (POOL_1) and created a NAT statement that says... NAT traffic that matches the ACL 100 to an address in POOL_1. However, it doesnt seem to work, when I try to establish a connection I do not see any output from 'show ip nat translation'...am I missing something??

My Config...

interface FastEthernet0/0

ip nat outside

interface FastEthernet0/1

ip nat inside

ip nat pool POOL_1 192.168.178.42 192.168.178.45 netmask 255.255.255.248 type rotary

ip nat inside destination list 100 pool POOL_1

access-list 100 permit ip 10.1.1.1 0.0.0.255 host 192.168.80.19

Thanks in advance for any help

Steve

4 REPLIES
Hall of Fame Super Blue

Re: Destination NAT

Steve

Is that meant to be 10.1.1.0 0.0.0.255 rather than 10.1.1.1 that you have ?

Jon

New Member

Re: Destination NAT

yeah sorry, my typo....

access-list 100 permit ip 10.1.1.0 0.0.0.255 host 192.168.80.19

New Member

Re: Destination NAT

Just to let you know that I solved the problem using route-maps....

http://www.cisco.com/en/US/docs/ios/12_2t/12_2t4/feature/guide/ftnatrt.html

Thanks

Steve

Hall of Fame Super Silver

Re: Destination NAT

Steve

Thanks for posting back to the forum and indicating that you have found a solution and what the solution is. It makes the forum more useful when people can read about a problem and can read what solved the problem.

The forum is an excellent place to learn about Cisco networking. I encourage you to continue your participation in the forum.

HTH

Rick

132
Views
0
Helpful
4
Replies
CreatePlease login to create content