Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Destination NAT

 

hi,

We need to configure the NAT as per the below requirement.

source ip 10.1.1.5 /24

destination ip 172.20.0.10 

 

Now the source(10.1.1.5 ) will sent the packet to destination (172.20.0.10).

 

If only 10.1.1.5 sents packet to the 172.20.0.10 the destination should change to 10.5.0.10. ( 172.20.0.10 =>10.5.0.10 if source is 10.1.1.5 ).

 

Rest traffic should flow normally.

 

Kindly suggest any configuration.

 

Regards

 

Pushpak

  • LAN Switching and Routing
2 REPLIES
New Member

Hi,May i know where you want

Hi,

May i know where you want to configure NAT? router/firewall??

 

Regards,

Satya.M

New Member

Hi, We are configuring the

Hi,

 

We are configuring the NAT on CISCO Router 

 

Regards

 

Pushpak

69
Views
0
Helpful
2
Replies
This widget could not be displayed.