Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

Devices on switch

Good All

How do I check what devices are plugged into my switch. Which commands can I use to get the mac addresses of the devices plugged in?

2 REPLIES

Re: Devices on switch

Hi,

The command is show mac-address-table

Reference: http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.1E/native/command/reference/show2.html#wp2004764

Best regards.

Massimiliano.

Hall of Fame Super Gold

Re: Devices on switch

"sh mac-address-table" is the command, however, this will give you a very, very long list.

If you know a specific port, you can use the subcommand "sh mac-address-table interface ". Alternatively if you have the mac address and you want to know what port, you use the command "sh mac-address-table address ".

Hope this helps.

232
Views
0
Helpful
2
Replies
CreatePlease to create content