I have a server acting as a dhcp server connected to a 4506 core switch. I have closet switches (3750s) connected to it via fiber (trunked). I would like to give those switches ip addresses via dhcp. So I setup a dhcp reservation with the MAC address of what I think Vlan 1 is on the closet switch. I get an IP address but not the reserved one. Is there something special I need to do to get that switch to get the reserved IP address?
Jon, thanks for your reply. All of the other dhcp entries show a 12 digit number which looks like mac addresses. But my switch shows a 48 digit number. At first, I thought it might be an IPV6 address but those are 128 bit addresses. If I arp the IP address that is given out, it shows the vlan1 mac that I put in the reservation.
Debug to the rescue. After Jon's note (thanks Jon) I deceided to use debug to see what was going on. It turns out that that 48 digit number is actually the client-id in hexidecimal format. The switch makes up the client-id by using the word cisco followed by the mac address and then the abbreviated interface name like VL1 or such.
And of course you can set the client-id to anything you want (almost) by using the "ip dhcp client client-id" command. When i used this with the mac of the interface everything worked although I did have to drop the leading zeros in the reservation on the server. I guess the switch really wasn't sending them. Anyway, thanks for everyones help.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...