07-12-2012 04:36 AM - edited 03-07-2019 07:44 AM
Hi,
I was wondering whether someone could help me.
In my network setup I use, at least, two VLAN's in a Virtualized model. That is... I have each workstation with a Virtual Machine inside it. The host machine, is in VLAN Id 76 and the VM uses default VLAN.
Each VLAN has a separate DHCP server. The interface definition for the tagged VLAN is as follows
interface GigabitEthernet1/0/11
switchport access vlan 76
switchport trunk encapsulation dot1q
switchport mode access
priority-queue out
spanning-tree portfast
!
The NIC on the server has no definition for setting a VLAN, mostly because the server hasn't the latest Intel driver. Anyways I'm not sure that it is because of that... What happens? Everytime I turn on the computer, it takes more than a minute to assign an IP to the workstations. The same doesn't happen on the Virtual Machines... the VM's use the default VLAN...
The workstations have the following setup:
interface GigabitEthernet1/0/40
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,4,76
switchport mode trunk
switchport voice vlan 4
priority-queue out
mls qos trust device cisco-phone
mls qos vlan-based
spanning-tree portfast
Might there be any config in my 3750 that can help improve the time that the DHCP takes to deliver an IP to the workstations?
Thanks in advance.
Nuno Silva
07-12-2012 05:29 AM
Hi Nuno,
Try using the spanning-tree portfast trunk on the trunk ports towards the workstation. You currently have them configured with PortFast, however, such a configuration applies only to access ports. If you want a trunk port to be PortFast enabled, you have to use the spanning-tree portfast trunk command including the trunk optional keyword.
Note also that on your Gi1/0/11 port, the spanning-tree trunk encapsulation dot1q is superfluous - as the port is currently set to access mode, all spanning-tree trunk ... commands are ignored. You may remove that command, it will make your configuration easier to read and understand.
Best regards,
Peter
07-19-2012 07:19 AM
Hi Peter,
That was it! Did the change, and it is now working much faster.
Best regards,
Nuno Silva
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: