Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

DHCP Relay on FWSM

on our FWSM we use the "dhcprelay server x.x.x.x <network>" config to allow dhcp relay

is it possible to add more than 1 server address (need this for dhcp server failover)?

1 ACCEPTED SOLUTION

Accepted Solutions

DHCP Relay on FWSM

Yes you can up to four.

http://www.cisco.com/en/US/docs/security/fwsm/fwsm22/configuration/guide/ip.html#wp1155528

Please rate replies and mark question as "answered" if applicable.

Please rate replies and mark question as "answered" if applicable.
1 REPLY

DHCP Relay on FWSM

Yes you can up to four.

http://www.cisco.com/en/US/docs/security/fwsm/fwsm22/configuration/guide/ip.html#wp1155528

Please rate replies and mark question as "answered" if applicable.

Please rate replies and mark question as "answered" if applicable.
67
Views
0
Helpful
1
Replies
CreatePlease to create content