Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DHCP Snooping and Etherchannel config

Hello, I have a 2960 where I have gi0/1 and gi 0/2 boundled on a Channel po1. I enabled "ip dhcp snooping trust" on po1. What is trsange is that on gi0/1 and gi0/2 the command doesn't appear. What is right:

1) The command should'n appear cause is enabled only on logical interfaces PO1

2) command has to be placed manually also on gi0/1 ans gi0/2

-

-

1 REPLY
Hall of Fame Super Bronze

Re: DHCP Snooping and Etherchannel config

Commands placed under interface port-channel1 won't appear on its respective physical interfaces but commands applied to its respective physical interfaces will appear in the interface port-channel1.

397
Views
0
Helpful
1
Replies
CreatePlease login to create content