Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

DHCP Snooping on Catalyst 3850

Hello,

I am trying to configure DHCP snooping on a Catalyst 3850 running software version 03.03.04SE.

It just does not seem to work at all.

I have stripped the config right back to the basics but at no point can my clients get an IP address and the DHCP server does not see the requests.

Is there anything special that needs to be done on this switch to get this working?

I have followed the config guide and checked everything numerous times so I am sure the config is what is shown in the guide.

I have set this up numerous times on Catalyst 3560 and 3750 switches without any problems.

Any suggestions (other than raise a TAC case)

Thanks

 

126
Views
0
Helpful
0
Replies
CreatePlease login to create content