Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DIag in SXH1

Hi,

Please what does following mean :

%SPAN-SP-6-SPAN_EGRESS_REPLICATION_MODE_CHANGE :Span Egress HW Replication Mode Change Detected ( that I understand ).Current replication mode for unused asic session 0 is Centralized ??? Appears twice ,2nd it s session 1 which is involvezd.I never saw that in 122-33SXH ( ION form ) and I don t know where I can find any explanat.

Thanks

Francois

2 REPLIES
Silver

Re: DIag in SXH1

Could you post your show tech and show run?

New Member

Re: DIag in SXH1

Yes I ll do that.But what I can say is that if I unplug : slot 2 WS-X6516-GBIC Hw 5.5 Fw 6.3 and

slot 4 WS-X6516-GBIC ( same level Hw anf Fw ) and for both Sw 8.7(0.22) BUB, there is NO MSGS.

The only doc found about that is Doc-ID 44140,WS

6516-GBIC Compatibility issue with PFC3 and DFC3.Furthermore SRB SXH1 don t say anything about switching-mode = crossbar, thank s again Ed for the WP.In fact the two others cards ( slot 1 and 3 are WS-6516A-GBIC( Hw 4.2 Fw 7.2 )I don t play with VS, my Sups (2) are 720-3B, running RPR.

Best Regards

Francois

125
Views
0
Helpful
2
Replies