Throughput is the amount of information (pulses, bits, frames, packets, etc...) that can be sent through a conductor while it is under the stresses of real-life operation.
Bandwidth is the amount of information it is physically possible to send through the media of choice (copper, fiber)
For example; your ISP provides your 2MB bandwidth but actually you will be able to transfer lesser than 2MB the interface can delever,. after setting you bandwith for interface by using command """ bandwith 2000
always remember that if your channel capacity which is bendwidth C and your transmission rate is R... then keep in mind that transmission rate should always less then the channel capacity in order to obtain the proper communication... R
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...