I am confused about the aforementioned concepts, it would be helpful if some one can explain or point me to relevant documentation. Also i would like to know when do we use NSF comapared to NSR specially when using the routing protocols OSPF and BGP and which one is the better option. Further are there any dependencies like the partner node should be NSF or NSR aware.
I am currently using ASR9010 as the service provider PS backbone.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...