Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Difference in code

Hi all. I was wondering if anyone knew the difference in the IOS for a 6500 for a 12.2.33-SX(F) and a 12.2.33-SX(H)? The only difference is the last letter, and Im wondering if I can go from one to the other on the 6500 without worry. Anyone have any ideas? Thanks.

3 REPLIES
Purple

Re: Difference in code

There is probably not much difference if you are talking staying within the same feature set like "enterprise" otherwise you would have to use the feature navigator to see what is supported on each one.

Hall of Fame Super Silver

Re: Difference in code

Hello John,

we performed a massive upgrade from 12.2(18)SXF8 to 12.2(33)SXHa2 last may with no real issue.

However, they can have different coverage of service modules like FWSM,CSM, ACE and others.

In my case I can say that WiSM controller are supported because they are in two of the C6500 we have upgraded.

We have other nodes that have FWSM and flexwan but on them 12.2(33)SXH was tried but one of the two was not supported so they went back to 12.2SXF.

Hope to help

Giuseppe

New Member

Re: Difference in code

Thanks to both of you guys. I appreciate the input.

121
Views
8
Helpful
3
Replies
CreatePlease to create content