Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Different trunk encapsulation

I have a switch with an ISL for its uplink. If I add a redundant uplink and set trunk encapsulation to dot1q will the switch work on layer 3?

2 REPLIES
Bronze

Re: Different trunk encapsulation

Encapsulation is point to point or in other words from port X of switch A to port Y of switch B. For your dot1q trunk, just make sure native vlan is the same for both sides.

Now, your question about layer 3 is not very clear, do you have the switch connected to a router that is doing the inverlan routing? A little bit more of explanation will be needed.

New Member

Re: Different trunk encapsulation

Thanks.

133
Views
0
Helpful
2
Replies
CreatePlease to create content