Re: Directing traffic to multiple remote sites out a fastetherne
Yes, it can be done with no problems. Sub interfaces can be configured on Fast Ethernet ports also. This is like a router on a stick configuration.
The way I would achieve this is to purchase a switch and connect the 2851 to the switch via a trunk link. Create sub interfaces on the router for each remote site. Each sub interface would have the default gateway IP address for the remote site. I would then uplink the remote sites to this switch also via trunk links.
If your 2851 supports Gigabit Ethernet this would probably be a better option, depending on the size of the remote sites and the amount of traffic coming back to the router. You might also consider using a Gigabit switch so that your core is Gigabit Ethernet with Fast Ethernet at your access layer.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.