I am currently running a Cisco 3560 48 TS Switch with 12.2(25)SEE3. I am trying to disable version 1 of the protocol, but unable to. I have used no ip ssh version 1 and I still see SSHv1/2 Servers running with the show ssh command. Is there a command or set of commands to shut down ssh version 1 ?
a show ip version says version 1.99.
How do I get it to select 2.0 so it does not use version 1?
Configuring 'ip ssh version 2' should disable support for version 1.
Here's an excerpt from the link below.
Note SSH Version 1 is a protocol that has never been defined in a standard. If you do not want your router to fall back to the undefined protocol (Version 1), you should use the ip ssh version command and specify Version 2.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.