Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Disable Errdisable detection

Hello guys,

I would like to know if there is a function for us to disable errdisable state detection in IOS.

Normally any interfaces will go to errdisable state because of many possible causes such as duplex mismatch.

I am hoping to avoid the interface to go to errdisable state even if there is duplex mistmatch etc which for sure will bring the interface down.

Thanks a lot

SiraJ

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Disable Errdisable detection

Hi SiraJ,

You can simply do this via the "no errdisable detect cause x" command, but this is highly not recommended as it is a safety feature.

BR,

Mohammed Mahmoud.

3 REPLIES

Re: Disable Errdisable detection

Hi SiraJ,

You can simply do this via the "no errdisable detect cause x" command, but this is highly not recommended as it is a safety feature.

BR,

Mohammed Mahmoud.

Re: Disable Errdisable detection

Hi

the below was taken from a 4500, duplex mistmach does not cause error disable. it will simply show up in log and cause CRC errors heavily.

HTH

Sam

ACC01#sh errdisable detect

ErrDisable Reason Detection status

----------------- ----------------

udld Enabled

bpduguard Enabled

security-violatio Enabled

channel-misconfig Enabled

psecure-violation Enabled

vmps Enabled

unicast-flood Enabled

pagp-flap Enabled

dtp-flap Enabled

link-flap Enabled

l2ptguard Enabled

gbic-invalid Enabled

dhcp-rate-limit Enabled

storm-control Enabled

ilpower Enabled

arp-inspection Disabled

Re: Disable Errdisable detection

Hi Sam,

Duplex mismatch doesn't have a specific errdisable detection mode, but please take care of the following, i quote from this document "Errdisable Port State Recovery on the Cisco IOS Platforms":

"Link flap means that the interface continually goes up and down. The interface is put into the errdisabled state if it flaps more than five times in 10 seconds. The common cause of link flap is a Layer 1 issue such as a bad cable, duplex mismatch, or bad Gigabit Interface Converter (GBIC) card."

http://www.cisco.com/en/US/tech/tk389/tk621/technologies_tech_note09186a00806cd87b.shtml

BR,

Mohammed Mahmoud.

7250
Views
0
Helpful
3
Replies