Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Disable stateless autoconfig

Guys, I have a question regarding stateless autoconfig. I want to disable it on a LAN interface for testing purposes. I have used the 'ipv6 nd suppress-ra' command to, what I thought, would prevent autoconfigurations, but as I look at the output of 'sh ipv6 int' command:

Vlan301 is up, line protocol is up

IPv6 is enabled, link-local address is FE80::20A:42FF:FEA1:A00 [TEN]

Global unicast address(es):

2706:F368:8009:6::1, subnet is 2706:F368:8009:6::/64 [TEN]

Joined group address(es):

FF02::1

FF02::2

FF02::1:FF00:1

FF02::1:FFA1:A00

MTU is 1500 bytes

ICMP error messages limited to one every 50 milliseconds

ICMP redirects are enabled

ND DAD is enabled, number of DAD attempts: 1

ND reachable time is 30000 milliseconds

Hosts use stateless autoconfig for addresses.

you can see from the very last line of output that stateless configuration is alive and well. Does anyone know how I can truly disable it? Thanks.

1 REPLY

Re: Disable stateless autoconfig

Note, I want to disable stateless autoconfiguration for the hosts, just to be clear.

973
Views
0
Helpful
1
Replies