11-08-2014 03:32 AM - edited 03-07-2019 09:25 PM
A few day ago, i recieved an old Cisco 867VAE-W-E-K9, and i want to disable the wlan function on it.
I cant get manage to shut the wlan-GigabitEthernet0.
Its says:
"% Shutdown not allowed on Wlan-GigabitEthernet0 interface, as it is an internal interface connecting to the wlan-ap module."
There was an command to enter the embedded ap (wlan-ap0?) inside it, but my cisco doesnt recognize that command (service wlan-ap 0.......)
Cant find any documentation for it either to disable it.
I hope you guys can help me out with this.
11-08-2014 05:09 AM
Router(config)#service-module wlan-ap 0 session
^
% Invalid input detected at '^' marker.
running from console, not ssh
11-08-2014 11:05 AM
Somewhere it says, you need to connect to service-module wlan-ap 0. What if my cisco doesnt recognize this command. The cisco is using the standard bootimage. Tried several things, but all doesnt help.
Nevermind found it.
(config)#interface loopback 0
(config-if)#ip address 1.1.1.1 255.255.255.255
#telnet 1.1.1.1 2002
- login with admin/admin first time, and change password
- conf t
ap(config)#interface Dot11Radio 0
ap(config-if)#shutdown
Wlan disabled after this.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: