Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Disabling Flow Control on 2851

Does anyone know how to disable flow-control on a 2851 Gigabit Ethernet interface? I do not want pause frames being sent to the switch which has flow-control turned off.

Thanks,

Mike

3 REPLIES
Super Bronze

Re: Disabling Flow Control on 2851

I might be mistaken, but I thought pause frames were only sent if the other side confirmed it understood them.

New Member

Re: Disabling Flow Control on 2851

On switchport, the following line appears:

input flow-control is off, output flow-control is unsupported

Super Bronze

Re: Disabling Flow Control on 2851

Appears then that flow control was not negotiated to be active?

458
Views
0
Helpful
3
Replies