Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

Disabling Load Balance on GLBP to act as HSRP

Can I setup GLBP to act as HSRP so that later I can take advantage of load balancing?

Per

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/ipras_r/ip1_d1g.htm#wp1084940

I am assuming I can use:

glbp 1 priority 150

glbp 1 preempt

glbp 1 load-balancing host-dependent

glbp 1 weighting 254 lower 1 upper 254

2 REPLIES

Re: Disabling Load Balance on GLBP to act as HSRP

You probably want to change load-bal to weighted, and set weight to 254 on one and 1 on the other, removing the tracking options.

Better still if you want HSRP behaviour, use HSRP!

Super Bronze

Re: Disabling Load Balance on GLBP to act as HSRP

What you're trying, I believe, will still allow some traffic onto the other gateway. If you really want to not load balance, you would be better using HSRP (as Paul suggests) or VRRP.

Assuming, that some leakage is acceptable, and you want to do load balancing later on, using GLBP as you describe would be better so that the virtual MACs need not change.

243
Views
0
Helpful
2
Replies