Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Disabling / Skipping POST diagnostics on 2960

I have a situation where I need to decrease the amount of required to boot a 2960 switch. Currently, it's timed at 3.5 minutes. There used to be a "diaglevel" command in CatOS to skip post tests -- is there anything like that in the IOS for a 2960? I'm using 12.2(25)SEE2.

Thanks!

1 REPLY
Silver

Re: Disabling / Skipping POST diagnostics on 2960

There is no such option on 2960 to reduce the boot time.Performs power-on self-test (POST) for the CPU subsystem. It tests the CPU DRAM and the portion of the flash device that makes up the flash file system. Refer URL

http://www.cisco.com/en/US/products/ps6406/products_configuration_guide_chapter09186a00805a75f0.html#wp1021427

189
Views
0
Helpful
1
Replies