Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

distance commands parameter

hi every body

i have a question regarding " distance"

command. here is the sample configuration

router ospf 1

network 10.0.0.0

distance 145 10.10.10.1 0.0.0.255 3

!

access-list 3 permit 2.0.0.0

in the above configuration " 10.10.10.1"

is router id supplying the routing information or the ip address of an interface supplying the information?

thanks

1 ACCEPTED SOLUTION

Accepted Solutions

Re: distance commands parameter

For OSPF, the IP address and address mask entered for the distance command should match the source address and address mask of the OSPF router that sent the link-state advertisement (LSA).

The OSPF router would be the router ID

HTH

Narayan

1 REPLY

Re: distance commands parameter

For OSPF, the IP address and address mask entered for the distance command should match the source address and address mask of the OSPF router that sent the link-state advertisement (LSA).

The OSPF router would be the router ID

HTH

Narayan

101
Views
0
Helpful
1
Replies