Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DLNA Media Server is not showing on diffrent Vlans

Hi all,

i have a media Server in one Vlan now i want to access it from other Vlans as well. for DLNA i configure Multicast and PIM Spare mode with rp address on Cisco 4500x L3 switch and enable IGMP snooping on all my Layer 2 switches but still not able to show my DLNA in other Vlans

DLNA in Vlan2

want to show in it in Vlan3 and Vlan4

here is my L3 Switch configuration foe PIM

ip routing

ip multicast-routing

int vlan 2

ip add 192.168.2.1 255.255.255.0

ip pim sparse-mode

int vlan 3

ip add 192.168.3.1 255.255.255.0

ip pim sparse-mode

int vlan 4

ip add 192.168.4.1 255.255.255.0

ip pim sparse-mode

ip pim rp-address 192.168.2.1

10 REPLIES
Hall of Fame Super Blue

DLNA Media Server is not showing on diffrent Vlans

Have you checked the TTL setting on the DNLA server ?

Jon

New Member

DLNA Media Server is not showing on diffrent Vlans

yea 2

Hall of Fame Super Blue

DLNA Media Server is not showing on diffrent Vlans

Can you post "sh ip mroute "

Jon

New Member

DLNA Media Server is not showing on diffrent Vlans

sh ip mroute 239.255.255.250

IP Multicast Routing Table

Flags: D - Dense, S - Sparse, B - Bidir Group, s - SSM Group, C - Connected,

       L - Local, P - Pruned, R - RP-bit set, F - Register flag,

       T - SPT-bit set, J - Join SPT, M - MSDP created entry, E - Extranet,

       X - Proxy Join Timer Running, A - Candidate for MSDP Advertisement,

       U - URD, I - Received Source Specific Host Report,

       Z - Multicast Tunnel, z - MDT-data group sender,

       Y - Joined MDT-data group, y - Sending to MDT-data group,

       G - Received BGP C-Mroute, g - Sent BGP C-Mroute,

       Q - Received BGP S-A Route, q - Sent BGP S-A Route,

       V - RD & Vector, v - Vector

Outgoing interface flags: H - Hardware switched, A - Assert winner

Timers: Uptime/Expires

Interface state: Interface, Next-Hop or VCD, State/Mode

(*, 239.255.255.250), 16:39:10/00:02:57, RP 192.168.2.1, flags: SJC

  Incoming interface: Null, RPF nbr 0.0.0.0

  Outgoing interface list:

    Vlan2, Forward/Sparse, 00:27:03/00:02:56

    Vlan3, Forward/Sparse, 02:08:20/00:02:56

    Vlan4, Forward/Sparse, 12:20:31/00:02:57

New Member

DLNA Media Server is not showing on diffrent Vlans

Still Searching for Solution

Hall of Fame Super Blue

DLNA Media Server is not showing on diffrent Vlans

My apologies, i missed your last reply.

Can you do a quick test and change to dense mode ie.

switch(config)' int vlan 2

switch(config-if)# no ip pim sparse-mode

switch(config-if)# ip pim dense-mode

for each vlan and see what happens.

Jon

New Member

DLNA Media Server is not showing on diffrent Vlans

jon thanks for the response I changed PIM mode already i am using spare-dense-mode on every vlan

like:

switch(config)' int vlan 2

switch(config-if)# ip pim sparse-dense-mode

But still not working for me

Hall of Fame Super Blue

DLNA Media Server is not showing on diffrent Vlans

Did you remove the RP config when you ran sparse-dense-mode ? If not, can you and try again.

Other than that can you describe your toppology, is it just a L3 switch with L2 switches connected via trunks ?

Jon

New Member

Re: DLNA Media Server is not showing on diffrent Vlans

Jon i am sorry for late reply yea it just L3 switch with L2 switches and Lightweight Access point Multicast snooping and broadcast farwording is enabled  at Wireless Controller .

And i didnt remove RP .

New Member

DLNA Media Server is not showing on diffrent Vlans

core-2960#sh ip igmp snooping detail

Global IGMP Snooping configuration:

-------------------------------------------

IGMP snooping                : Enabled

IGMPv3 snooping (minimal)    : Enabled

Report suppression           : Enabled

TCN solicit query            : Disabled

TCN flood query count        : 2

Robustness variable          : 2

Last member query count      : 2

Last member query interval   : 1000

Vlan 1:

--------

IGMP snooping                       : Enabled

CAPWAP enabled                      : Disabled

IGMPv2 immediate leave              : Disabled

Multicast router learning mode      : pim-dvmrp

CGMP interoperability mode          : IGMP_ONLY

Robustness variable                 : 2

Last member query count             : 2

Last member query interval          : 1000

Topology change                     : No

What is pim-dvmrp ...Multicast listening mode

1193
Views
0
Helpful
10
Replies
CreatePlease login to create content