05-02-2010 09:59 AM - edited 03-06-2019 10:54 AM
I have the following config:
IBM PCOM on E0 <-> CISCO 2600 12.3 <-> CISCO 7500 12.2 <-> SNASW <-> M/F
------------------------------------------------------------------------------<-> CIP LAN Tok <-> M/F
CISCO 2600 Config
source-bridge ring-group 200
dlsw local-peer peer-id xxx.xxx.xxx.xxx
dlsw remote-peer 0 tcp yyy.yyy.yyy.yyy
dlsw bridge-group 30
int FastEthernet 0/1
bridge-group 30
bridge 30 protocol ieee
-------------------------------------------
CISCO 7500 Config
source-bridge ring-group 20
source-bridge transparent 20 13 1 14
dlsw local-peer yyy.yyy.yyy.yyy
dlsw remote-peer 0 tcp xxx.xxx.xxx.xxx
int Channel 0/2
lan TokenRing 0
source-bridge 1 1 20
adapter 0 4000.0000.0001
int FastEthernet 5/1
bridge-group 14
bridge 14 protocol ieee
int Virtual-TokenRing0
mac-addr 4000.eeee.0002
source-bridge 25 1 20
source-bridge spanning
snasw cpname xxxx.yyyy
snasw dlus aaaaa.bbbbb
snasw port HPRIP hpr-ip FastEthernet 5/0
snasw port VTOK0 Virtual-TokenRing0 conntype-nohpr
snasw link HOSTCIP2 port HPRIP ip-dest zzz.zzz.zzz.zzz
-----------------------------------------------------------------------------
I can connect from IBM PCOM through DLSW and CIP using mac-addr 4000.0000.0001
I can connect from IBM PCOM on local 7500 Ethernet and SNASW using mac-addr 4000.eeee.0002
I - CANNOT - connect from IBM PCOM through DLSW and SNASW using mac-addr 4000.eeee.0002
What am I missing?
Thanks
05-03-2010 03:47 AM
Are there no SNASW experts out there?
10-26-2010 07:32 AM
Do you still need any help for this ?
Matthew
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: