Anyone knows the answer that we upgrade IOS and replaced module for 6509 but after that DLSW circuit is not being established. The connection is like We have router --> router (Remote and local dlsw peer) then go to switch 6509 (which we replaced module and upgrade IOS and then go to HOST. Module replace has a lower version then the OLD module. Is this the issue for HW or SW.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...