I have a Web Server connected to the RV220w. I set up the DMZ host to point to it's Lan address. I also set up a 1 to 1 NAT with the Private address pointing to the public address. From outside the fire wall I can access the web server.
But when I put the URL in the internet explorer on a workstation behind the firewall I get the Router Login Page. Internally I can only access the web server by either putting in the Lan IP address of the Web Server or use the NETBIOS name. Is there any way that users behined the firewall can access the web server using the URL?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...