Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

do we have any issues if we enable automatic erro dsable recovery on switch

Do we have any issues when we enable automatic error recovery enabled on a switches port.

does some one know any kinda issue when we enable that on a port which might cause a link to come back after time interval and does this bring a link to go bad?

Thnx

1 ACCEPTED SOLUTION

Accepted Solutions
Purple

Re: do we have any issues if we enable automatic erro dsable rec

There is no problem using it but you have to remember that the error did not just happen by itself and probably will not go away by itself and should be investigating as to why the link is flapping or whatever the err-disable error is . It would not make a link go bad , if its causing an error there is already some type of problem on the link.

2 REPLIES
Purple

Re: do we have any issues if we enable automatic erro dsable rec

There is no problem using it but you have to remember that the error did not just happen by itself and probably will not go away by itself and should be investigating as to why the link is flapping or whatever the err-disable error is . It would not make a link go bad , if its causing an error there is already some type of problem on the link.

New Member

Re: do we have any issues if we enable automatic erro dsable rec

Thank u so much

94
Views
0
Helpful
2
Replies