vPC is virtual port channel, and allows a port channel to cross 2 chassis. Since VSS takes 2 chassis and makes them 1 logical chassis, it basically does the same thing, without the added configuration.
Just create the VSS system. Then create a portchannel with ports in both chassis. Thats it!
Or are you asking if you can create a vPC using multiple VSS systems (not one system)?
That I know would work fine, but I am thinking of (1) port channel with two physical port from Cisco 6509 (VSS) going to (2) different upstream switches. The two upstream switches are not VSS, and connected via Fiber as a Layer II. I don't think it is doable.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...