Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Does Cisco 10000PRE2 support EtherChannel?

Greetings.

We have a Cisco 10000PRE2 router running in ISG mode with the following config:

Cisco IOS Software, 10000 Software (C10K2-P11-M), Version 12.2(31)SB11, RELEASE SOFTWARE (fc3)

NAME: "Chassis", DESCR: "C10000 Edge Service Router (ESR) Chassis"

PID: ESR10008-CHASSIS , VID: V02 , SN: FOX10461842

NAME: "module 1/0", DESCR: "1 port Gigabit Ethernet Half-Slot Line Card"

PID: ESR-HH-1GE , VID: V01 , SN: CAT1039530R

NAME: "module 2/0", DESCR: "1 pt Gigabit Ethernet line card (requires a GBIC)"

PID: ESR-1GE , VID: , SN: CAT10465NRH

NAME: "module 3/0", DESCR: "1 pt Gigabit Ethernet line card (requires a GBIC)"

PID: ESR-1GE , VID: , SN: CAT10465NM8

NAME: "RP A", DESCR: "Performance Routing Engine"

PID: ESR-PRE2 , VID: V02 , SN: CAT10455FYE

NAME: "RP A flash card 0", DESCR: "Flash Card"

PID: ESR-PRE-MEM-FD128 , VID: , SN:

NAME: "power-supply 0", DESCR: "AC power entry module for ESR10008"

PID: ESR-PWR-AC , VID: , SN:

NAME: "fan-tray", DESCR: "BLOWER ASSEMBLY FOR ESR10008"

PID: ESR-BLOWER , VID: , SN:

No matter how i tried, i could not get two or three of these network cards working int GigabitEtherChannel mode, however, this link: http://www.cisco.com/en/US/docs/ios/12_2sb/feature/guide/sbcelacp.html says it's possible. Ports (including Port-Channel interface itself) go up, but no frames are passing through. Had anyone success with this matter?

Or, does anyone know, if 10G module is planned for this chassis? I have nearly 900M of traffic passing through it, and desperately need some reserve.

Thanks a lot!

2 REPLIES
Silver

Re: Does Cisco 10000PRE2 support EtherChannel?

The 802.1q support on GEC for c10k (PRE-2 and PRE-3) will be available in 12.2SB release-5. We are currently working on getting the 802.1q support on GEC into the release-4 throttle branch. It should be available in future rebuilds out of the 12.2(31) SB.

New Member

Re: Does Cisco 10000PRE2 support EtherChannel?

Thanks a lot for your answer!

I'm not quite sure i understand though: 12.2SB release 5 is older that 12.2SB31, or not? And how about 12.2(33).SB, that became available recently? Will 'ip subscriber routed' will be supported on 802.1q-based vlans on GEC?

Thanks again.

161
Views
0
Helpful
2
Replies