Hello Hitesh,
I wish to describe the situation more clearly.
Scheme:
switch A:e24 ----- e1:Switch B
Trunk e24-e1 is 802.1Q. Linksys does not support another types.
Current configuration of switches:
Switch A:
-----------------------------------------------
sw_A# show run
interface range ethernet e(2-23)
shutdown
exit
interface ethernet e24
description sw4:e1
exit
interface range ethernet e(1,24)
switchport mode trunk
exit
vlan database
vlan 300,303
exit
interface range ethernet e(1,24)
switchport trunk allowed vlan add 300
exit
interface ethernet e2
switchport access vlan 303
exit
interface range ethernet e(1,24)
switchport trunk allowed vlan add 303
exit
interface vlan 300
name Management
exit
interface range ethernet e(1,24)
gvrp enable
exit
interface ethernet e1
gvrp vlan-creation-forbid
exit
gvrp enable
interface ethernet e1
gvrp registration-forbid
exit
interface vlan 300
ip address 10.10.255.4 255.255.255.0
exit
ip default-gateway 10.10.255.1
hostname sw_A
----------------------------------------------
Switch B:
----------------------------------------------
sw_B# show run
interface range ethernet e(3-24)
shutdown
exit
interface ethernet e1
switchport mode trunk
exit
interface ethernet e1
gvrp enable
exit
gvrp enable
hostname sw_B
-----------------------------------------------
On the switch B I see dynamic VLANs that it learned from switch A:
sw_B# show vlan
Vlan Name Ports Type Authorization
---- ----------------- --------------------------- ------------ -------------
1 1 e(1-24),g(1-4),ch(1-8) other Required
300 300 e1 dynamicGvrp Required
303 303 e1 dynamicGvrp Required
But when I'm trying to add a port on switch B to any of VLANs I get an error:
sw_B(config)# int eth e2
sw_B(config-if)# switchport mode access
sw_B(config-if)# switchport access vlan 300
VLAN 300: VLAN was not created by user.
Regarding the mode that I run for GVRP: I don't undestand what did yoy mean... :(
I haven't seen any modes for GVRP on linksys.
It is just enabled globally and enabled on trunk port:
sw_B# show gvrp configuration
GVRP Feature is currently Enabled on the device.
Maximum VLANs: 255
Port(s) GVRP-Status Registration Dynamic VLAN Timers(milliseconds)
Creation Join Leave Leave All
-------- ----------- ------------ ------------ ---- ----- ---------
e1 Enabled Normal Enabled 200 600 10000
e2 Disabled Normal Enabled 200 600 10000
e3 Disabled Normal Enabled 200 600 10000
e4 Disabled Normal Enabled 200 600 10000
e5 Disabled Normal Enabled 200 600 10000
...
