Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Dose Cisco 3850 support PBR with Tracking?

Hi

Configured PBR in Cisco 3850 ,But i can't find policy route map in my interface.

route-map test1 permit 10

match ip address PBR_server

set ip next-hop verify-availability 10.3.2.1 1 track 1

Core_IDC3850#sh track

Track 1

  IP SLA 1 state

  State is Up

    10 changes, last change 00:01:16

  Latest operation return code: OK

  Latest RTT (millisecs) 1

  Tracked by:

    ROUTE-MAP 0

show route-map

route-map test1, permit, sequence 10

  Match clauses:

    ip address (access-lists): PBR_server

  Set clauses:

    ip next-hop verify-availability 10.3.2.1 1 track 1  [up]

*************

Core_IDC3850#conf t

Enter configuration commands, one per line.  End with CNTL/Z.

Core_IDC3850(config)#int vlan 2

Core_IDC3850(config-if)#ip poli

Core_IDC3850(config-if)#ip policy rou

Core_IDC3850(config-if)#ip policy route-map test1

Core_IDC3850(config-if)#exit

Core_IDC3850(config)#do sh run int vlan2

Building configuration...

Current configuration : 60 bytes

!

interface Vlan2

ip address 172.16.1.1 255.255.255.0

end

Core_IDC3850(config)#

My switch ver.

Switch Ports Model              SW Version        SW Image              Mode  

------ ----- -----              ----------        ----------            ----  

*    1 32    WS-C3850-24T       03.03.01SE        cat3k_caa-universalk9 INSTALL

3 REPLIES
Purple

Dose Cisco 3850 support PBR with Tracking?

Hi,

Have you changed your SDM template ? I think you need Advanced template for PBR  and which licence have you got installed( you need IPBase) ?

Regards

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
New Member

Dose Cisco 3850 support PBR with Tracking?

Hi Alain,

  My C3850 SDM prefer advance and licence is ip service.

If i remove verify-availability  the PBR running correct.


Core_IDC3850#sh sdm prefer

Showing SDM Template Info

This is the Advanced (high scale) template.

  Number of VLANs:                                 4094

  Unicast MAC addresses:                           32768

  Overflow Unicast MAC addresses:                  512

  IGMP and Multicast groups:                       8192

  Overflow IGMP and Multicast groups:              512

  Directly connected routes:                       32768

  Indirect routes:                                 7680

  Security Access Control Entries:                 3072

  QoS Access Control Entries:                      3072

  Policy Based Routing ACEs:                       1024

  Netflow ACEs:                                    1024

  Input Microflow policer ACEs:                    256

  Output Microflow policer ACEs:                   256

  Flow SPAN ACEs:                                  256

  Tunnels:                                         256

  Control Plane Entries:                           512

  Input Netflow flows:                             8192

  Output Netflow flows:                            16384

  SGT/DGT entries:                                 4096

  SGT/DGT Overflow entries:                        512

These numbers are typical for L2 and IPv4 features.

Some features such as IPv6, use up double the entry size;

so only half as many entries can be created.

Core_IDC3850#sh license right-to-use

Slot#  License name   Type     Count   Period left

----------------------------------------------------------

1      ipservices   permanent     N/A   Lifetime

route-map test1 permit 10

match ip address PBR_server

set ip next-hop 10.3.2.1

Core_IDC3850#                  conf t

Enter configuration commands, one per line.  End with CNTL/Z.

Core_IDC3850(config)#int vlan 2

Core_IDC3850(config-if)#ip policy route-map test1

Core_IDC3850(config-if)#^Z

Core_IDC3850#sh run int vlan 2

Building configuration...

Current configuration : 87 bytes

!

interface Vlan2

ip address 172.16.1.1 255.255.255.0

ip policy route-map test1

end

Core_IDC3850#

Regards,

Horace


check my other post for

check my other post for answer

https://supportforums.cisco.com/discussion/12357181/route-map-not-taken-3850-ip-services#comment-10091941

1535
Views
0
Helpful
3
Replies
CreatePlease to create content