Re: Dot1q tag not appear on SPAN destination port on 6513
You need to configure the destination port as trunk, setting is to non-negotiate and the chosen encapsulation type.
Then, configure the monitor session to use it as destination port.
Note that the sequence here is important. You have to configure destination port first and then configure the SPAN session, a restriction removed in some latest releases. There is no need to specify the encapsulation type in SPAN session configuration in 6500, as for 3750. Please try it out and update if it works for you.
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...