I'm trying to setup a dot1q tunnel on a 3560X, but the option does not seem available.
SW02#conf t Enter configuration commands, one per line. End with CNTL/Z. SW02(config)#int gig 0/1 SW02(config-if)#sw mode ? access Set trunking mode to ACCESS unconditionally dynamic Set trunking mode to dynamically negotiate access or trunk mode trunk Set trunking mode to TRUNK unconditionally
I'm sure I have seen this command visible previously so it could be configuration or VTP related, but obviously am now doubting myself.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.