12-17-2013 01:11 AM - edited 03-07-2019 05:06 PM
Hello
I have a cisco 2960s switch with universalk9 lanbase image and it does not support the dot1x multiple-host or single-mode under any of the interface.Someone may please help. The license activated is for lanbase.
Regards.
Solved! Go to Solution.
12-17-2013 04:06 AM
If you have a recent IOS, then the command is not "dot1x host-mode ...". It's "authentication host-mode ...".
Here is a very good reference for dot1x:
http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6586/ps6638/whitepaper_c27-574041.pdf
--
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni
12-17-2013 04:06 AM
If you have a recent IOS, then the command is not "dot1x host-mode ...". It's "authentication host-mode ...".
Here is a very good reference for dot1x:
http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6586/ps6638/whitepaper_c27-574041.pdf
--
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni
12-17-2013 05:47 AM
Hi karsten
I have ios 15.0 and the command is actually "authentication host-mode " as you mentioned .
Thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: