Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

dot1x multiple-host in 2960s

Hello

I have a cisco 2960s switch with universalk9 lanbase image and it does not support the dot1x multiple-host or single-mode under any of the interface.Someone may please help. The license activated is for lanbase.

Regards.

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

dot1x multiple-host in 2960s

If you have a recent IOS, then the command is not "dot1x host-mode ...". It's "authentication host-mode ...".

Here is a very good reference for dot1x:

http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6586/ps6638/whitepaper_c27-574041.pdf

-- 
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni

2 REPLIES
VIP Purple

dot1x multiple-host in 2960s

If you have a recent IOS, then the command is not "dot1x host-mode ...". It's "authentication host-mode ...".

Here is a very good reference for dot1x:

http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6586/ps6638/whitepaper_c27-574041.pdf

-- 
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni

New Member

dot1x multiple-host in 2960s

Hi karsten

I have ios 15.0 and the command is actually "authentication host-mode " as you mentioned .

Thanks.

91
Views
0
Helpful
2
Replies
CreatePlease to create content